CALCIUM ALPHA SIALON AS A PROMISING MATERIAL FOR ALUMINUM INDUSTRY: NANOPOWDER SYNTHESIS AND PRESSURELESS SINTERING

سال انتشار: 1391
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 1,606

فایل این مقاله در 11 صفحه با فرمت PDF قابل دریافت می باشد

استخراج به نرم افزارهای پژوهشی:

لینک ثابت به این مقاله:

شناسه ملی سند علمی:

IMES06_213

تاریخ نمایه سازی: 8 بهمن 1391

چکیده مقاله:

A polyacrylamide hydrogel route was successfully developed for the preparation of Ca-α-SiAlON balls composed of nanoparticles with the stoichiometric composition of Ca1Si9Al3O1N15. An aqueous solution was first made containing the complex cations and nano silica. This aqueous solution was then gelled to a three dimensional (3D) tangled network, i.e. polyacrylamide hydrogel. The gel was dried and obtained xerogel was calcined under N2 flow up to1450 °C for 1h. The Ca-α-SiAlON phase was formed during carbothermal reduction and nitridation (CRN) process. In this work pre carbon polymer/nano silica/Al3+/Ca2+ mixture was used as a new type of precursor. Due to homogeneity of mixture constituents at molecular level, the soaking time ofoptimal synthesis condition was reduced to 1h. FESEM investigation of the resultant powder showed that ball-shaped Ca-α-SiAlON was obtained at 1450 °C after 1h. It was found that very fine nanoparticles (> 30nm) were formed on the surface of the balls after CRN process. Moreover, the ball-milled nanopowder was sintered under N2 atmosphere by pressureless sintering (PLS). This nitride ceramic exhibits high Vickers hardness (13.5 GPa) and proper fracture toughness (4.82 MPa m1/2) .These all imply that Ca-α-SiAlON ceramics are promising candidate for aluminum industry.

کلیدواژه ها:

Ca-α-SiAlON ، Nanoparticles ، Polyacrylamide ، Hydrogel ، Aluminum industry ، Carbothermal reduction and nitridation (CRN) process

نویسندگان

Iman Najafi Hajivar

Nanotechnology Group, Faculty of Engineering, Tarbiat Modares University, P.O. Box: ۱۴۱۱۵-۱۴۳

Mehrdad Kokabi

Polymer Engineering Department, Faculty of Chemical Engineering, Tarbiat Modares University,

مراجع و منابع این مقاله:

لیست زیر مراجع و منابع استفاده شده در این مقاله را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود مقاله لینک شده اند :
  • Metselaar, G.Z. R. d'-SiAlON ceramics: a review, Chem Mater. 1991, ...
  • Wang, P.L, Zhang, C., Sun, W.Y., Yan, D.S., Characteristic of ...
  • Rutten, J.W.T., Terpstra, R.A. J., van der Heijde _ C.T., ...
  • morphology in Ca-d-SiAlON ceramics by changing the heating rate, J. ...
  • Li, Y.W., Wang, L.P., Chen, W.W., Cheng, B.Y., Yan, D.S. ...
  • Komeya, K., Zhang, C., Hotta, M., Tatami, J., Meguro, T. ...
  • Hotta, M., Tatami, J., Komeya, K., Zhang, C., Meguro, T., ...
  • Hewett, Cheng, C.L., Muddle, Y.B. B.C., Trigg, M.B. Thermal stability ...
  • Hui-Li, _ Hirosaki, N., Xie, R.J., Suehiro, T., Mitomo, M., ...
  • Cheng, Y.B., Terner, M.R., Chen, W.W., Wang, P.L. Slag derived ...
  • Ekstrom T., Shen, Z.J., Mackemzie, K.J.D., Brown, I.W.M., White, G.V. ...
  • Mitomo, M., Takeuchi, M., Ohmasa, M. Preparation of od-SiAlON powders ...
  • Li, Z., Ghosh , A. , Kobayashi, A.S. , Bardat, ...
  • Chen, K., Jin, H., Oliveira, ...
  • formation mechanism of co mbust ion- synthesized rodlike Ca-d-SiAlON crystal ...
  • Hotta, M., Tatami, J., Zhang, C., Komeya, K., Meguro, T., ...
  • Xie, Z.H., Hoffman, M., Cheng, Y.B. Micro structural tailoring and ...
  • نمایش کامل مراجع