Chemical energy and bottom stirring systems – Cost effective solutions for a better performing EAF
سال انتشار: 1388
نوع سند: مقاله ژورنالی
زبان: انگلیسی
مشاهده: 91
فایل این مقاله در 5 صفحه با فرمت PDF قابل دریافت می باشد
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
JR_ISSIRAN-6-1_001
تاریخ نمایه سازی: 6 آبان 1402
چکیده مقاله:
The continuous improvement of EAF performance is crucial for the increase in productivity and cost effectiveness and to render an environmental friendly process. RHI supports these targets by providing a diverse range of refractory and process solutions. Chemical energy in practical operation by injection of gaseous media like oxygen and natural gas, and solid materials like carbon have become a state of the art solutions for process improvement today. To understand the phenomena of the benefits, RHI has developed a mass and energy balance model. The objective of the model is to focus on the replacement ratio of electrical energy by chemical energy and the consequences for the overall CO۲ emission of the process. CO۲ emission certificate trading can become a new source for cash generation to be utilized for improvement investment budgets. Another valuable solution to decrease the energy consumption and the CO۲ generation of the process is bottom purging in EAF. This technology can be introduced by the use of the directional porosity plug (DPP). The benefit of stirring in the furnace is that it enhances the interface reactions between the slag and the bath and homogenizes the liquid volume in the furnace. This results in achieving better operation parameters in terms of less power consumption and power-on time. Again a benefit in cost and a reduction in carbon dioxide emissions can obviously be attained. This paper shows the savings potential of the replacement of electrical energy by chemical energy by using the mentioned balance model. The benefit of the introduction of the DPP system is shown on the results of various steel plants.
کلیدواژه ها:
نویسندگان
M. Kirschen
RHI Technology Centre Leoben
K. Badr
Metallurgical Department, RHI AG, Vienna
J. Cappel
Metallurgical Department, RHI AG, Vienna
مراجع و منابع این مقاله:
لیست زیر مراجع و منابع استفاده شده در این مقاله را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود مقاله لینک شده اند :