Optimization of Pressure Profile and V/P Switchover Point to Minimizing the Warpage in a Thin-Wall Plastic Injection Molded Part
سال انتشار: 1402
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 127
فایل این مقاله در 7 صفحه با فرمت PDF قابل دریافت می باشد
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
ICISE09_101
تاریخ نمایه سازی: 15 مهر 1402
چکیده مقاله:
This research has focused on the minimization of warping in plastic-injected parts by optimizing the shape of the pressure profile. The importance of this method is that the mutual effects of the input parameters are seen and the location of the V/P switchover point is also determined. For this purpose, ۵ input parameters including flow velocity, filling time, packing pressure, packing time, and cooling time have been considered in ۴ levels and in Taguchi L۱۶ format. The results for a polypropylene belt as a case study have been done using FDM analysis in the SolidWorks Plastics plugin. Variance analysis of the results led to the signal-to-noise diagram, which was used to determine the optimal values and finally the desired pressure profile shape. The results show that cooling time and filling time have ۵۷% and ۲۷% effects on the warpage, respectively, and other inputs have no significant effect. Also, the pressure phase is about ۹ times more effective than the velocity phase. On the other hand, reducing the warpage requires an increase in cooling and packaging times, which leads to an increase in the cycle time which is costly. Therefore, it is necessary to make a technical compromise between the cycle time and the targeted warping amount.
کلیدواژه ها:
نویسندگان
Hamid Haghshenas Gorgani
Engineering Skills Education Center, Sharif University of Technology, Tehran, Iran;
Ali Saedi
Mechanical Engineering Department, Sharif University of Technology, Tehran, Iran