Investigation of Fracture Depth of Metal-Polymer Three‑Layer Sheet in Single-Point Incremental Forming Process
محل انتشار: مجله شکل دهی مواد، دوره: 10، شماره: 1
سال انتشار: 1402
نوع سند: مقاله ژورنالی
زبان: انگلیسی
مشاهده: 92
فایل این مقاله در 14 صفحه با فرمت PDF قابل دریافت می باشد
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
JR_IJMF-10-1_005
تاریخ نمایه سازی: 28 خرداد 1402
چکیده مقاله:
Incremental forming is one of the new forming methods. Single-point incremental forming (SPIF) has shown significant potential for forming complex metal parts. In the single-point incremental forming, a spherical tool head moves along a pre-defined path to form the desired geometry. The aim of this study is to optimize the fracture depth and forming forces of the three-layer metal-polymer sheet by using the single-point incremental forming process. By using response surface methodology (RSM), a series of experiments were designed in which tool diameter, step down and spindle speed were considered as process input parameters. The influencing parameters in fracture depth and forming forces have been identified by using statistical tools (response table, main effect diagram and ANOVA). Analysis of variance was used to show potential differences between the means of variables by testing the population value in each sample, which enables it to show the effects of input variables on output variables. The results show that the forming forces increased and the formability decreased by increasing the step down and the tool diameter. The highest forming force is ۱۴۷۶ N and the lowest value is ۱۰۴۵ N. Similarly, the highest fracture depth is ۸.۸ mm and the lowest is ۷.۱ mm. The best conditions are achieved when spindle speed is ۲۳۴۰.۹ rpm, tool diameter is ۷.۵۱۹۷۸ mm, and vertical step is ۰.۳۲۹۵۵۲ mm. In this condition, the fracture depth is ۸.۵۰۵۵۲ mm and the forming force is ۷۷۶.۰۳ N.
کلیدواژه ها:
Incremental sheet forming ، Metal–polymer three‑layer sheet fracture depth ، ANOVA ، Forming Force ، Fracture depth
نویسندگان
M. Esmailian
Faculty of Mechanics, Malek Ashtar University of Technology, Iran
M. Honarpisheh
Faculty of Mechanical Engineering, University of Kashan, Kashan, Iran
A. Gheysarian
Faculty of Mechanical Engineering, University of Kashan, Kashan, Iran
مراجع و منابع این مقاله:
لیست زیر مراجع و منابع استفاده شده در این مقاله را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود مقاله لینک شده اند :