سیویلیکا را در شبکه های اجتماعی دنبال نمایید.

Study the Deformation Behavior of 7075 Alloy under Backward Extrusion process for Producing Cone Shaped Parts

سال انتشار: 1400
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 252

فایل این مقاله در 7 صفحه با فرمت PDF قابل دریافت می باشد

استخراج به نرم افزارهای پژوهشی:

لینک ثابت به این مقاله:

شناسه ملی سند علمی:

SETCONG01_053

تاریخ نمایه سازی: 22 آذر 1401

چکیده مقاله Study the Deformation Behavior of 7075 Alloy under Backward Extrusion process for Producing Cone Shaped Parts

Nowadays, the extrusion process has an important role in the production of parts with high mechanical properties and quality in high-tech industries. In this study, the deformation behavior of aluminum alloy 7075, which is a very applicable alloy in the aerospace industry, has been studied under the backward extrusion process to produce conical parts. In this regard, the finite element simulation was performed by ABAQUS software. In this research, the variations of imposed plastic strain along the part’s thickness have been investigated under different frictional conditions. The mesh sensitivity test also was performed to obtain more accurate results. The error of simulation results was about 10%, which indicates the high accuracy of the simulation. The maximum amount of deformation load was about 73 KN at the friction coefficient of 0.15, which was observed after 80% of the punch displacement. Eventually, this is concluded that by increasing the friction coefficient, the amount of imposed plastic strain has been increased. The average plastic strain in this process was about 1 which will result in better mechanical properties of the product. The results showed that by using backward extrusion in producing conical parts in the aircraft industry, this is possible to use more lightweight products with better mechanical properties

کلیدواژه های Study the Deformation Behavior of 7075 Alloy under Backward Extrusion process for Producing Cone Shaped Parts:

نویسندگان مقاله Study the Deformation Behavior of 7075 Alloy under Backward Extrusion process for Producing Cone Shaped Parts

Sanaz Sefiddashti

Department of Aerospace Engineering, OOJ Institute of Higher Education, Abyek,Qazvin, Iran.

Babak Manafi

Department of Mechanical Engineering, OOJ Institute of Higher Education, Abyek,Qazvin, Iran

Farzad Abdi

Department of Mechanical Engineering, Najafabad Branch, Islamic Azad University, Najafabad, Iran

Mohammad Najafi

Mechanical Engineering Department, College of Engineering, University of Tehran, Tehran, Iran