Effect of Pre-Heat Multi-Regions in Counterflow Combustion of Premixed Particle-Cloud
سال انتشار: 1392
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 203
متن کامل این مقاله منتشر نشده است و فقط به صورت چکیده یا چکیده مبسوط در پایگاه موجود می باشد.
توضیح: معمولا کلیه مقالاتی که کمتر از ۵ صفحه باشند در پایگاه سیویلیکا اصل مقاله (فول تکست) محسوب نمی شوند و فقط کاربران عضو بدون کسر اعتبار می توانند فایل آنها را دریافت نمایند.
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
ISME21_385
تاریخ نمایه سازی: 17 آبان 1401
چکیده مقاله:
In this paper, the structure of lycopodium volatile particles flame is analytically studied in counterflow configuration. In this investigation, it is presumed that the gaseous fuel, produced from vaporization of the fuel particles, oxidizes in the gas phase and the fuel particles do not participate in the reaction. The structure of flame is considered to have three zones including the pre-heat zone, the asymptotically thin reaction zone and post flame zone. Also, uniformly dispersed particles in the gas phase passes throughout four sub-regions in preheat zone including; first pre-heat sub-region, drying sub-region, second pre-heat sub-region and vaporization (devolatilisation) sub-region, respectively. The analysis is carried out in the asymptotic limit and one-step chemical reaction is assumed. The flame position is determined and the effect of Lewis number change and sub-regions in pre-heat zone on the gaseous fuel mass fraction and fuel particles mass fraction distribution is investigated. Also, the effect of volatile temperature is studied on the gaseous fuel mass fraction versus nondimensional length.
کلیدواژه ها:
Particle-cloud ، Counterflow combustion ، Multi-regions ، Drying ، Vaporization of volatile particles
نویسندگان
Mahdi Bidabadi
Asscociate Professor, Combustion Research Laboratory, Department of Mechanical Engineering, Iran University of Science and Technology (IUST)
Ali Esmaeilnejad
PhD Student, Combustion Research Laboratory, Department of Mechanical Engineering, Iran University of Science and Technology (IUST)