Weld Distortion and Residual Stresses in Aluminum Hollow Section T-Joint

سال انتشار: 1401
نوع سند: مقاله ژورنالی
زبان: انگلیسی
مشاهده: 112

فایل این مقاله در 6 صفحه با فرمت PDF قابل دریافت می باشد

استخراج به نرم افزارهای پژوهشی:

لینک ثابت به این مقاله:

شناسه ملی سند علمی:

JR_ADMTL-15-1_010

تاریخ نمایه سازی: 9 شهریور 1401

چکیده مقاله:

Welding is known as one of the most popular attaching methods for different hollow section components. However, local concentrated heating, distortion, and residual stresses at welded joints are unavoidable. In this article, the welding simulation for rectangular hollow (RHS) sections for the front axle carrier of the new BMW series-۷ is discussed and weld distortion and residual stresses in its aluminum T-joint for one proposed sequence are investigated. Comparisons of the results of this paper for this recommended sequence with experimental results in some references show good agreement and indicate that characteristics of the welding distortions are fully forecasted. In the following of this paper, the Finite Element Method (FEM) is used to offer a better sequence with smaller weld distortion and residual stresses. Weld distortion and residual stresses are highly influenced by welding strategy. In the proposed strategy, the needed time to perform the welding process decreased, and the total weld distortion and residual stresses decreased by ۲۴% and ۴%, respectively.

نویسندگان

Asghar Mahdian

Faculty of Mechanics, Malek Ashtar University of Technology, Isfahan, Iran

Arash Babamiri

Faculty of Mechanics, Malek Ashtar University of Technology, Isfahan, Iran

Behrooz Shahriari

Faculty of Mechanics, Malek Ashtar University of Technology, Isfahan, Iran

مراجع و منابع این مقاله:

لیست زیر مراجع و منابع استفاده شده در این مقاله را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود مقاله لینک شده اند :
  • Murakawa, H., Deng, D., Rashe, S., and Sato, S., Prediction ...
  • Tsai, C. L., Cheng, W. T., and Lee, T., Modelling ...
  • Bachorski, A., Painter, M. J., Smailes, A. J., and Wahab, ...
  • Hackmair, C., Werner, E., and Pönisch, M., Application of Welding ...
  • Vural, M., Muzafferoglu, H., and Tapici, U., The Effect of ...
  • Guangming, F., Marcelo, I., Menglan, D., Segen, F., Influence of ...
  • Summers, P., Chen, Y., Rippe, Ch., Allen, B., Mouritz, A., ...
  • Incropera F., Dewitt D., Fundamentals of Heat and Mass Transfer, ...
  • نمایش کامل مراجع