The effects of height and width in L-loop characteristics: ۳D analysis using finite element method
محل انتشار: دوفصلنامه ارتودنسی ایران، دوره: 5، شماره: 1
سال انتشار: 1389
نوع سند: مقاله ژورنالی
زبان: انگلیسی
مشاهده: 150
فایل این مقاله در 6 صفحه با فرمت PDF قابل دریافت می باشد
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
JR_ORTHO-5-1_001
تاریخ نمایه سازی: 25 بهمن 1400
چکیده مقاله:
Desirable tooth movements need optimal force systems. Loops are employed to move teeth properly. L-loop is used frequently due to its ease of fabrication. The aim of this study is to assess the expected forces and moments when a definite length of wire is bent to form L-loop. In other words, the effect of loop height and width on the produced force and moment is evaluated by the finite element method (FEM). Materials and methods: Six ۳D finite element models were designed of an L-loop without pre-activation bends keeping the total lengths of wire equal to ۲۴.۳۴+/- ۰.۵ mm. The cross section of wire was ۰.۰۱۶”× ۰.۰۲۲”. The force produced by activation in a ۰.۱ millimeter increment was recorded. Results: In model L۱, the findings start with ۰.۰۸۶ N in ۰.۱ mm of activation and increased to ۰.۸۸ N in ۱mm of loop opening. The pattern of findings was almost the same for other loop designs (L۲ through L۶) with an increase in findings. M/F ratios were almost constant in a loop design along its activation starting with ۳ in L۱ and reaching about ۱.۹-۲ in L۶. Conclusions: Moment to force ratios were almost constant in a loop design along its activation. increasing width and decreasing height with almost the same length of loop wire can increase force and therefor reduce M/F ratio.
کلیدواژه ها:
نویسندگان
Allahyar Geramy
Professor Dental Research Center and Orthodontics Department Tehran University of Medical Sciecnes
Tahoora Etezadi
Post graduate Student Orthodontics Department, Tehran University of Medical Sciences