Agricultural wastes as renewable fillers in physical granulation of NPK fertilizers: Evaluation of on-size granules and comparison to conventional filler
سال انتشار: 1399
نوع سند: مقاله ژورنالی
زبان: انگلیسی
مشاهده: 165
فایل این مقاله در 17 صفحه با فرمت PDF قابل دریافت می باشد
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
JR_ROWA-9-2_002
تاریخ نمایه سازی: 18 بهمن 1400
چکیده مقاله:
Purpose This research aimed to evaluate the yield and quality of granular NPK fertilizers prepared by physical granulation with eggshell, snail shell, and cow bone as fillers and to compare them to conventional filler. Methods Urea, DAP, KCl, and fillers were milled separately and mixed to the desired formula. About ۱۵۰ g of mixed powders were granulated on a disc granulator in ۹ minutes, at a rotation speed of ۳۵ rpm and a disc slope of ۴۵°. Water at a desired additional moisture was sprayed on the tumbled powders to facilitate the granulation. The obtained granules were then dried and screened into three fractions: undersize ( ۴ mm). Results Snail shells and eggshells as fillers were found to give on-size NPK granules having yield and compressive strength which were comparable to that with limestone as a conventional filler. For NPK ۱۵-۱۵-۱۵, using snail shells and eggshells as fillers, the yields of on-size granules achieved ۴۶% and ۵۶%, respectively, and the compressive strengths of on-size granules reached ۲.۴ and ۲.۱ MPa, respectively. Cow bones as fillers resulted in low compressive strength. The distribution of nutrients in the NPK granules was found to be close to the targeted formula. Conclusion Snail shells and eggshells as fillers have good yield and quality of on-size NPK granules and are very potential alternatives to limestone.
کلیدواژه ها:
نویسندگان
- -
Research Group on Chemical Engineering Product Design and Development, Faculty of Industrial Technology, Institut Teknologi Bandung, Jalan Ganesa ۱۰, Bandung ۴۰۱۳۲, Indonesia
- -
Study Program of Chemical Engineering Magister, Faculty of Industrial Technology, Institut Teknologi Bandung, Jalan Ganesa ۱۰, Bandung ۴۰۱۳۲, Indonesia
- -
Research Group on Chemical Engineering Process Design and Development, Faculty of Industrial Technology, Institut Teknologi Bandung, Jalan Ganesa ۱۰, Bandung ۴۰۱۳۲, Indonesia
مراجع و منابع این مقاله:
لیست زیر مراجع و منابع استفاده شده در این مقاله را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود مقاله لینک شده اند :