Investigation of Air Flow Characteristics in Air Intake Hoses using CFD and Experimental Analysis based on Deformation of Rubber Hose Geometry

سال انتشار: 1398
نوع سند: مقاله ژورنالی
زبان: انگلیسی
مشاهده: 277

فایل این مقاله در 10 صفحه با فرمت PDF قابل دریافت می باشد

استخراج به نرم افزارهای پژوهشی:

لینک ثابت به این مقاله:

شناسه ملی سند علمی:

JR_JAFM-13-3_010

تاریخ نمایه سازی: 15 دی 1400

چکیده مقاله:

In this study, the pressure loss value of air intake hose of FIAT ۱.۳ E۶D type engine, located between intercooler and inlet manifold of the engine, was examined using computational fluid dynamics, considering geometrical deformation in a rubber material. The rubber material modelling was performed by the verification of the data - obtained through the experimental method- with ANSYS software using Mooney-Rivlin method. The rubber material modelling was performed with the aim of correctly determination of the increase in the hose diameter when subjected to pressure, since the material has the feature of elasticity. In this study, ANSYS Fluent v.۱۸.۰ software and a static pressure machine were used. The air intake into the hose took place at the pressure of ۱۲۳,۵ kPa and flow rate of ۰,۰۸۷ kg/s. A solution, independent of the number of element, was obtained in the analysis. The turbulence model used in the study is standard k-ε type. As a result, the deformation-oriented pressure loss in the last geometry was found ۱,۸۵ kPa. The analyses were repeated for non-deformed geometry, and a pressure loss of ۲,۰۴ kPa was determined. At the result of the test, the geometry was seen to become actually deformed, and the pressure loss was found ۱,۹ kPa. The lowness of pressure loss in the deformed geometry was seen as the removal of the sharp bends that would cause local losses with the effect of pressure forces. In this study, it was determined that geometrical deformation changes the geometrical features that causes pressure loss, and leads to less pressure loss.

نویسندگان

K. Furkan Sokmen

Bursa Technical University, Faculty of Engineering and Natural Science, Mechanical Engineering Department, Bursa, ۱۶۳۳۰, Turkey

O. Bedrettin Karatas

Bursa Technical University, Faculty of Engineering and Natural Science, Mechanical Engineering Department, Bursa, ۱۶۳۳۰, Turkey