The Processing–Morphologies Relationships in Microcellular Foaming of ABS/TPU Sheets
محل انتشار: کنفرانس بین المللی فرآورش پلیمرها
سال انتشار: 1390
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 1,273
فایل این مقاله در 5 صفحه با فرمت PDF قابل دریافت می باشد
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
PPSRC2011_025
تاریخ نمایه سازی: 30 بهمن 1390
چکیده مقاله:
In this paper an experimental study on the batch processing of ABS/TPU blends is reported. A microcellular plastic is a foamed polymer with a cell density greater than 109cells/cm3 and fully grown cells smaller than 10 μm. In the present study the microcellular ABS/TPU foamed structure are developed by first saturating a polymer sample with a volatile blowing agent followed by rapidly decreasing the solubility of the blowing agent in the polymer. The microstructure of the foamed samples was controlled by carefully altering the processing parameters; saturation pressure, foaming temperature, and foaming time. Foam morphologies were characterized in terms of the cell density, foam density, and average cell size. The resulting density and the foam morphology can be related to the pressure level during the saturation process. Results also show that the size of the generated cells mainly depends on the foaming temperature.
کلیدواژه ها:
نویسندگان
Sara khaleghi khorrami
Mechanical Engineering Department, Faculty of Engineering, Urmia University, Urmia, Iran
مراجع و منابع این مقاله:
لیست زیر مراجع و منابع استفاده شده در این مقاله را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود مقاله لینک شده اند :