Experimental investigation of EDM process parameters by using Pongamia Pinnata osil blends as dielectric medium
سال انتشار: 1400
نوع سند: مقاله ژورنالی
زبان: انگلیسی
مشاهده: 155
فایل این مقاله در 10 صفحه با فرمت PDF قابل دریافت می باشد
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
JR_JCARME-11-1_005
تاریخ نمایه سازی: 12 مهر 1400
چکیده مقاله:
Electro Discharge Machining (EDM) is an incredibly recognizable machining for ticklishness profiles in ’difficult to machine ‘materials. In EDM, the material ejection of the cathode is cultivated through exact controlled electric pulse (the flash), which changes the metals of two terminals into dissolve and vaporize, as a result of the breakdown of the dielectric medium. The most commonly used dielectric media are kerosene, paraffin, glycerin, transformer oil, and EDM oil; all are derived from petroleum. These dielectric media undergo pyrolysis and carbon soot formation is deposited on work electrode, and sometimes carbon precipitates into work. To overcome these effects vegetable oils are tried as alternate dielectric media. Pongamia Pinnetta is abundantly available in most countries; and it is cheaper and non-edible. Pongamia Pinnata (PP) oil is extracted from plant seeds, and is blended with EDM oil and several experimentations are done to find its suitability. Operational variables with respect to input and output parameters are identified. Some of these are best EWR, MRR, TWR, and SR with applied current (I), pulse on time (Ton), and pulse off time (Toff) are the ones picked as the input process factors; because for the industrial application many machinists choose these three as the input parameters; and other is constant and picked under specific requirements only. After the successful completion of this experimentations, Pongamia Pinnata oil blends are fit for the industrial application using technique of order preferancing with similar to ideal solution [TOPSIS]. It is observed that no carbon soot formation takes place in the work component with PP oil as the dielectric fluid.
کلیدواژه ها:
Electrode Wear Rate (EWR) ، Material Removal Rate (MRR) ، Tool Wear Rate (TWR) ، Surface Roughness (SR) ، Scanning Electron Microscope (SEM) ، TOPSIS
نویسندگان
Dastagiri -
Department of Mechanical Engineering, Assistant Professor, Annamacharya Institute of Technology and Sciences, Rajampet, Andhra pradesh, India.
Srinivasa Rao P.
Department of Mechanical Engineering, Centurion University of Technology and Management, India
Madar Valli P.
Department of Mechanical Engineering, S.V College of Engineering, India
مراجع و منابع این مقاله:
لیست زیر مراجع و منابع استفاده شده در این مقاله را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود مقاله لینک شده اند :