Study of Rock Pillar Failure Consisting of Non-Persistent Joint using Experimental Test and Fracture Analysis Code in Two Dimensions

سال انتشار: 1400
نوع سند: مقاله ژورنالی
زبان: انگلیسی
مشاهده: 296

فایل این مقاله در 17 صفحه با فرمت PDF قابل دریافت می باشد

استخراج به نرم افزارهای پژوهشی:

لینک ثابت به این مقاله:

شناسه ملی سند علمی:

JR_JMAE-12-1_012

تاریخ نمایه سازی: 21 اردیبهشت 1400

چکیده مقاله:

The experimental and numerical methods were used to investigate the effects of joint number and joint angle on the failure behaviour of rock pillars under a uniaxial compressive test. The gypsum samples with dimensions of ۲۰۰ mm × ۲۰۰ mm × ۵۰ mm were prepared. The compressive strength of the intact sample was ۷.۲ MPa. The imbeded joint was placed inside the specimen. The joint length was ۶ cm in a constant joint length. There were several numbers of cracks including one, two, and three cracks. In the experimental tests, the angles of the diagonal plane with respect to the horizontal axis were ۰, ۳۰, ۶۰, and ۹۰ degrees. The axial load was applied to the model with a rate of ۰.۰۱ mm/s. In the fracture analysis code, the angles of the diagonal plane with respect to the horizontal axis were ۰, ۱۵, ۳۰, ۴۵, ۶۰, ۷۵, and ۹۰ degrees. A constant axial load of ۱۳۵ MPa was applied to the model. The results obtained showed that the failure process was mostly dependent on the angle and number of the non-persistent joint. The compressive strength of the samples was dependent on the fracture pattern and the failure mechanism of the discontinuities. It was shown that the tensile cracks were developed whithin the model. The strength of the specimens increased by increasing both the joint angle and joint number. The joint angle of ۴۵°  KI had the maximum quantity. The stress intensity factor was decreased by increasing the joint number. The failure pattern and failure strength were analogous in both methods, i.e. the experimental testing and the numerical simulation methods.

کلیدواژه ها:

نویسندگان

V. Sarfarazi

Department of Mining Engineering, Hamedan University of Technology, Hamedan, Iran

H. Karimi Javid

Department of Mining Engineering, Hamedan University of Technology, Hamedan, Iran

K. Asgari

Department of Mining Engineering, Shahid Bahonar University of Kerman, Kerman, Iran

مراجع و منابع این مقاله:

لیست زیر مراجع و منابع استفاده شده در این مقاله را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود مقاله لینک شده اند :
  • Bieniawski Z. T., Van Heerden W. L., (1975) The significance ...
  • Esterhuizen GS. (2006) Evaluation of the strength of slender pillars. ...
  • P. R. Sheorey, (1993) Design of coal pillar arrays and ...
  • Munjiza A. The combined finiteediscrete element method. John Wiley and ...
  • Jing L, Stephansson O. Fundamental of discrete element methods for ...
  • Ghazvinian E, Diederichs MS, Quey R. 3D random Voronoi grain-based ...
  • Lisjak A, Grasselli G. A review of discrete modeling techniques ...
  • Farahmand K, Diederichs MS. A calibrated synthetic rock mass (SRM) ...
  • Yan C, Zheng H, Sun G, Ge X. (2016) Combined ...
  • Mayer JM, Stead D. Exploration into the causes of uncertainty ...
  • Fadeev A. B., E. K. Abdyldayev, Rock Mech., (1979) Elastoplastic ...
  • G. Murali Mohan, P. R. Sheorey, A. Kushwaha, (2001) Numerical ...
  • Li W., Bai J., Peng S. et al., (2015) “Numerical ...
  • Zhang G. C., He F L, Jia H G et ...
  • Shabanimashcool M., Li C. C., (2012) Numerical modelling of longwall ...
  • Peng L. J., Zhang D. F., Guo Z. B. et ...
  • Yu B., Zhang Z., Kuang T. et al., (2016) “Stress ...
  • L. Lifeng, G. Weili, J. Wang, H.n Deng, Q. Jiang ...
  • Mortazavi, A., Hassani, F.P., and Shabani, M. A numerical investigation ...
  • Kaiser, P.K. and Tang, C.A. Numerical simulation of damage accumulation ...
  • Jaeger, J.C. and Cook, N.G.W., Fundamentals of Rock Mechanics, 4th ...
  • Do, N.A., Dias, D., Oreste, P., and Djeran-Maigre I. 2D ...
  • Do, N.A., Dias, D., Oreste, P., and Djeran-Maigre, I. Three-dimensionsal ...
  • Do, N.A., Dias, D., Oreste, P., and Djeran-Maigre, I. Three-dimensionsal ...
  • Ranjbarnia, M., Oreste, P., and Fahimifar, A. Analytical-numerical solution for ...
  • Yaylacı Murat, Avcar Mehmet (2020). Finite element modeling of contact ...
  • Uzun Yaylacı, E., Yaylacı, M., Ölmez, H. and Birinci, A., ...
  • Yaylacı Murat,Terzi Cemalettin, Avcar Mehmet (2019). Numerical analysis of the ...
  • Öner Erdal,Yaylaci Murat,Birinci Ahmet (2015). Analytical solution of a contact ...
  • Yaylaci Murat,Birinci Ahmet (2013). The receding contact problem of two ...
  • Yaylaci Murat, Öner Erdal, Birinci Ahmet (2014). Comparison between Analytical ...
  • Adiyaman Gökhan,Birinci Ahmet,Öner Erdal,Yaylaci Murat (2016). A receding contact problem ...
  • نمایش کامل مراجع