Experimental Investigation of Laser Power Effect on Growth Rate of Intermetallic Compound in Al/Cu Bimetal Produced by Laser Cladding Method

سال انتشار: 1395
نوع سند: مقاله ژورنالی
زبان: انگلیسی
مشاهده: 244

فایل این مقاله در 12 صفحه با فرمت PDF قابل دریافت می باشد

استخراج به نرم افزارهای پژوهشی:

لینک ثابت به این مقاله:

شناسه ملی سند علمی:

JR_ADMTL-9-1_003

تاریخ نمایه سازی: 18 اردیبهشت 1400

چکیده مقاله:

The aim of this project is to fabricated an aluminium-copper bimetal through the fusion method and examine its performance. An aluminium-copper-aluminium bimetal was built by the laser cladding method. The laser power as well as the annealing time effects on its interfacial properties of the bonding’s formed through the laser cladding were investigated. To fabricate the multilayer bimetal, the laser beam characteristic including the beam radios, and Transverse Electromagnetic Mode (TEM), and focusing conditions were considered in a heat source model. The model was, next, integrated within SYSWELD package to predict the temperature distribution and clad bead profile during the laser cladding of the pre-placed copper powder layer on the aluminium substrate. After the samples preparation, the intermetallic compounds formed at the joints were explored through the Scanning Electron Microscopy (SEM) and Energy Dispersive Spectroscopy (EDS) processes. Based on the experimental results, a laser power increase from ۱۱۰۰ W to ۱۱۵۰ W increases the intermetallic compound width, while an increase of ۱۱۵۰ W to ۱۲۰۰ W does not have much effect on the width. Also, increasing the annealing time results, increases the intermetallic compound thickness. In addition, based on obtained experimental results, four specimens are detected at the bimetal interface, one of which has ۷۳.۴ % copper and ۲۶.۱ % aluminium. The results also indicate that, with increasing both the laser power and annealing time, the electrical resistance of the samples decrease.

نویسندگان