Effect of AFM Cantilever Geometry on the DPL Nanomachining Process
سال انتشار: 1395
نوع سند: مقاله ژورنالی
زبان: انگلیسی
مشاهده: 187
فایل این مقاله در 6 صفحه با فرمت PDF قابل دریافت می باشد
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
JR_ADMTL-9-4_008
تاریخ نمایه سازی: 18 اردیبهشت 1400
چکیده مقاله:
With the development of micro and nanotechnology, machining methods at micro and nanoscale have now become interesting research topics. One of the recently-proposed methods for sub-micron machining, especially nanomachining, is dynamic plowing lithography (DPL) method. In this method an oscillating tip is used for machining soft materials such as polymers. The geometry of the oscillating beam and its vibrational properties are the most important parameters in this nanomachining process. In this study, effects of the AFM beam geometry on its stiffness coefficient, resonant frequency, beam stability, and the maximum stress created in the beam structure were investigated for ۱۲ different general shapes using the finite element method. The obtained results indicate that circular and square membranes are the most favourable AFM cantilever geometries because these structures provide higher machining force and speed; while for noisy conditions and environments, straight and V-shaped beams are recommended (because of their higher stability factor) for the DPL nanomachining process.
کلیدواژه ها:
نویسندگان
A. R. Norouzi
Department of New Sciences and Technologies, University of Tehran, Tehran, Iran
M. Tahmasebipour
Faculty of New sciences and Technologies, University of Tehran, Tehran, Iran
مراجع و منابع این مقاله:
لیست زیر مراجع و منابع استفاده شده در این مقاله را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود مقاله لینک شده اند :