Experimental investigation on the FDM process parameters effect on the mechanical properties of polymer-metal composite

سال انتشار: 1399
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 485

متن کامل این مقاله منتشر نشده است و فقط به صورت چکیده یا چکیده مبسوط در پایگاه موجود می باشد.
توضیح: معمولا کلیه مقالاتی که کمتر از ۵ صفحه باشند در پایگاه سیویلیکا اصل مقاله (فول تکست) محسوب نمی شوند و فقط کاربران عضو بدون کسر اعتبار می توانند فایل آنها را دریافت نمایند.

استخراج به نرم افزارهای پژوهشی:

لینک ثابت به این مقاله:

شناسه ملی سند علمی:

ISME28_090

تاریخ نمایه سازی: 22 تیر 1399

چکیده مقاله:

In this paper, metal-particle Acrylonitrile Butadiene Styrene (ABS) composite with 5% weight fraction of copper micro particles mechanical properties in Fused Deposition Modelling (FDM) is studied and compared to pure ABS material. The preparation process is started by drying the ABS granule. To produce composite filaments, the copper particles are mixed with ABS granule in a single screw extruder. Following that, the most effective parameters on ultimate tensile strength of printed part in FDM process is specified. Furthermore, for designing experiments, Taguchi DOE method is used. For evaluation of each FDM process effectiveness on samples ultimate tensile strength, the ANOVA analysis is employed. As a result, the process parameters which has the highest effects on ultimate tensile strength of printed pure and composite sample are layer thickness and filling pattern. According to the obtained results, filling ABS with micro copper particles by 5%wt would improve ultimate tensile strength of printed part by 14.36%.

کلیدواژه ها:

نویسندگان

Mohammad Reza Hashemi

Ms.c Student, Amirkabir University of technology, Tehran;

Hamed Adibi

Assistant professor, Amirkabir University of technology, Tehran;