Fabrication and Characterization of Nanostructured Mg-Doped Fluorapatite by Mechanical Aloying
محل انتشار: سومین کنفرانس نانوساختارها
سال انتشار: 1388
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 1,702
متن کامل این مقاله منتشر نشده است و فقط به صورت چکیده یا چکیده مبسوط در پایگاه موجود می باشد.
توضیح: معمولا کلیه مقالاتی که کمتر از ۵ صفحه باشند در پایگاه سیویلیکا اصل مقاله (فول تکست) محسوب نمی شوند و فقط کاربران عضو بدون کسر اعتبار می توانند فایل آنها را دریافت نمایند.
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
CNS03_222
تاریخ نمایه سازی: 21 دی 1388
چکیده مقاله:
Properties of hydroxyapatite (HA) or fluorapatite (FA), such as bioactivity, biocompatibility, solubility and adsorption properties can be tailored over a wide range by modifying the composition via ionic substitutions. The aim of this work was preparation and characterization of Mg-doped FA nanostructured powders. Mg-doped fluorapatite (FA) nanostructured powders with different Mg contents were prepared by mechanical alloying. The
designated degree of substitution of Ca2+ by Mg2+ in the mixture was indicated by the x value in the general formula of Ca10−xMgx (PO4)6F2, where X= 0, 0.5, 1, 1.5 and 2. X-ray diffraction (XRD) and scanning electron microscopic (SEM) were used for characterization of obtained powders. Results indicate that Mg ions entered into the fluorapatite lattice and occupied Ca2+ sites. The incorporation of Mg ions into the fluorapatite caused the decrease of the lattice parameters. With increasing Mg content, the crystallinity of powders decreased while the degree of agglomeration of powders increased. The obtained powders had crystallite size about 42–60 nm.
کلیدواژه ها:
نویسندگان
M Kheradmandfard
Department of Materials Engineering, Isfahan University of Technology, Isfahan, Iran
M.H Fathi
Department of Materials Engineering, Isfahan University of Technology, Isfahan, Iran