Forming of Multilayer Sheet Metal by Drawing Process: An Analysis and FEM Simulation

سال انتشار: 1397
نوع سند: مقاله ژورنالی
زبان: انگلیسی
مشاهده: 285

فایل این مقاله در 18 صفحه با فرمت PDF قابل دریافت می باشد

استخراج به نرم افزارهای پژوهشی:

لینک ثابت به این مقاله:

شناسه ملی سند علمی:

JR_IJMF-5-2_003

تاریخ نمایه سازی: 30 دی 1397

چکیده مقاله:

In this paper, the drawing process of multilayer sheet metal through a wedge-shaped die has been analyzed using stream function and upper bound method. Typically, a sandwich sheet contains three layers of metal, where the outer layers are of the same thickness and material and different from those of the inner layer. In this study, a new deformation model has been introduced in which inlet and outlet shear boundaries are considered flexible and the effect of work hardening of sheet layer materials has been considered. According to the suggested stream function, velocity field, strain rates and powers have been calculated. The optimized geometry of the deformation zone and the required drawing force have been determined depending on the process conditions. Analytical results including the drawing force and thickness of the sheets in the outlet of the die have been compared with the finite element (FE) results. The FE results have good congruence with the analytical ones. Finally, the effects of friction factor and reduction in thickness have been investigated on the drawing force and the optimum die angle.

نویسندگان

Y Mollapour

Department of Mechanical Engineering, University of Zanjan, Zanjan, Iran

D Afshari

Department of Mechanical Engineering, University of Zanjan, Zanjan, Iran

H Haghighat

Department of Mechanical Engineering, Razi University, Kermanshah, Iran