An Experimental Study of Nanofluids Operated Shell and Tube Heat Exchanger with Air Bubble Injection
محل انتشار: ماهنامه بین المللی مهندسی، دوره: 31، شماره: 1
سال انتشار: 1396
نوع سند: مقاله ژورنالی
زبان: انگلیسی
مشاهده: 392
فایل این مقاله در 8 صفحه با فرمت PDF قابل دریافت می باشد
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
JR_IJE-31-1_019
تاریخ نمایه سازی: 1 اردیبهشت 1397
چکیده مقاله:
Shell and Tube heat exchangers are the heat exchangers that are most widely used in industries and for other commercial purposes. There are many techniques that have been utilized to enhance the heattransfer performance of the shell and tube heat exchangers. Air bubble injection is one of the promising and inexpensive techniques that can create turbulence in the fluids resulting in to enhancement of heat transfer characteristics of the shell and tube heat exchangers. In this paper, experimental study of heat transfer characteristics have been done by injecting air bubbles at tube inlet and throughout the tube for 0.1%v/v and 0.2%v/v Al2O3 nanoparticle concentration. Results obtained at two different injection points for both concentrations are compared with the case when no air bubble injection is done. Theresults showed the enhancement in the heat transfer characteristics with air bubble injection and volumetric concentration of nanoparticles. The maximum enhancement was found to be in the case where air bubbles are injected throughout the tube which is followed by the air bubble injection at the tube inlet and without air bubble injection. As the bubbles were injected throughout the tube, approximately 22-33% enhancement was observed. The overall heat transfer coefficient with injecting air bubbles throughout the tube showed an enhancement of about 12-23% and 14-25% for 0.1% and 0.2% of nanofluids
کلیدواژه ها:
نویسندگان
G Thakur
Department of Mechanical Engineering, Chandigarh University, Gharuan, Punjab, India
G Singh
Department of Mechanical Engineering, Chandigarh University, Gharuan, Punjab, India
M Thakur
Department of Mechanical Engineering, Chandigarh University, Gharuan, Punjab, India
S Kajla
Department of Mechanical Engineering, Chandigarh University, Gharuan, Punjab, India