Study and Analysis of the Methods of Calculating Minimum Required Fluid Flow Rate for Cuttings Transport and Hole Cleaning
محل انتشار: دومین کنفرانس ملی ژئومکانیک نفت
سال انتشار: 1395
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 453
متن کامل این مقاله منتشر نشده است و فقط به صورت چکیده یا چکیده مبسوط در پایگاه موجود می باشد.
توضیح: معمولا کلیه مقالاتی که کمتر از ۵ صفحه باشند در پایگاه سیویلیکا اصل مقاله (فول تکست) محسوب نمی شوند و فقط کاربران عضو بدون کسر اعتبار می توانند فایل آنها را دریافت نمایند.
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
NPGC02_100
تاریخ نمایه سازی: 10 تیر 1396
چکیده مقاله:
In spite of many recent technology improvements in drilling, hole cleaning remains a significant challenge, especially in deviated and horizontal wells. Inadequate hole cleaning can result in several problems, such as bit wear, slow drilling rate, increased ECD (which can lead to formation fracturing), high torque, drag, and in the worst case, the drill pipe can be stuck.The critical mud flow rate for cleaning the well while drilling can be defined as the minimum annular fluid velocity, required to maintain a continuous upward movement of the cuttings, and no bed forming on the lower side of the wellboreThe paper employs two models developed by an empirical approach, namely Larsen‟smodel and Rubiandini‟s model and compare them with experimental. We observe, Larsen’s model is more reliable rather than Rubiandini;s model.
کلیدواژه ها:
نویسندگان
Masoud Noei
M.Sc. Student, Shahrood University of Thechnology
Mehrdad Sleimani Monfared
Assistant Professor of Student, Shahrood University of Thechnology.
Mohammad Fazaelizadeh
Assistant Professor of Student, Amirkabir University of Thechnology