Influence of Layer Thickness on the Tensile Properties of the Samples Manufactured by Fused Deposition Modelling
سال انتشار: 1395
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 406
متن کامل این مقاله منتشر نشده است و فقط به صورت چکیده یا چکیده مبسوط در پایگاه موجود می باشد.
توضیح: معمولا کلیه مقالاتی که کمتر از ۵ صفحه باشند در پایگاه سیویلیکا اصل مقاله (فول تکست) محسوب نمی شوند و فقط کاربران عضو بدون کسر اعتبار می توانند فایل آنها را دریافت نمایند.
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
ISPST12_280
تاریخ نمایه سازی: 6 اردیبهشت 1396
چکیده مقاله:
Nowadays, while fused deposition modelling (FDM) process is one of the most commonly-used additive manufacturing (AM) techniques due to its ability to manufacture very complex geometries, the major research issues have been focused on striking a balance between visual aesthetics and performance of the products manufactured by this method. In this study the effect of layer thickness on the tensile properties of poly lactic acid (PLA) samples were investigated. The results showed that the tensile strength and young modulus of the specimens decreased with the increase in layer thickness. Significant reduction of mechanical properties was obtained for the samples printed with 400μm layer thickness
کلیدواژه ها:
نویسندگان
Maryam Ezoji
Alborz Composites Eng. Co. R&D, Tehran, Iran
Mohammad Razavi-Nouri
Iran Polymer and Petrochemical Institute, Tehran, Iran
Amir Masood Rezadoust
Iran Polymer and Petrochemical Institute, Tehran, Iran
مراجع و منابع این مقاله:
لیست زیر مراجع و منابع استفاده شده در این مقاله را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود مقاله لینک شده اند :