Hot and Cold Tensile Behavior of Al 6061 Produced By Equal Channel Angular Pressing and Subsequent Cold Rolling
محل انتشار: مجله شکل دهی مواد، دوره: 2، شماره: 1
سال انتشار: 1394
نوع سند: مقاله ژورنالی
زبان: انگلیسی
مشاهده: 419
فایل این مقاله در 13 صفحه با فرمت PDF قابل دریافت می باشد
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
JR_IJMF-2-1_004
تاریخ نمایه سازی: 8 دی 1395
چکیده مقاله:
The full annealing AA6061 aluminum alloy was subjected to severe plastic deformationvia the combination of equal channel angular pressing (ECAP) and cold rolling (CR) in order torefine its microstructure and to improve its mechanical properties. According to the results of hotand cold tensile tests, the combination of ECAP and CR significantly affected the final strengthand ductility of studied AA6061. Four passes of ECAP followed by 90% reduction in rolling led toabout 5.4 and 3.15 times increase in the yield and ultimate tensile strengths, respectively. Inaddition, the hot ductility and strain rate sensitivity were increased by applying ECAP plus CR.The changes in mechanical properties were attributed to the enhanced dislocation density and tothe reduced grain size. The results show that a decrease in grains/subgrains size (0.37 μm) and anincrease in the fraction of high angle grain boundaries, exhibited significant effect on the hotductility of higher severe plastic deformed sample.
کلیدواژه ها:
نویسندگان
A.A Khamei
Department of Mining and Metallurgical Engineering, Amirkabir University of Technology, Tehran, Iran
K Dehghani
Department of Mining and Metallurgical Engineering, Amirkabir University of Technology, Tehran, Iran
S Bakhshi
Metallic Materials Research Center (MMRC-MA), Malkashtar University, Tehran, Iran
K Kalayeh
Department of Mechanical Engineering, University of Maryland, Baltimore County, USA