Design and Fabrication of the Mechanical Part of a Prototype Multileaf Collimator System
- سال انتشار: 1386
- محل انتشار: مجله فیزیک پزشکی ایران، دوره: 4، شماره: 2
- کد COI اختصاصی: JR_IJMP-4-2_002
- زبان مقاله: انگلیسی
- تعداد مشاهده: 180
نویسندگان
Professor, Medical Physics Research Center, Bu-Ali Research Institute, Mashhad University of Medical Sciences, Mashhad, Iran
Assistant Professor, Medical Physics Research Center, Bu-Ali Research Institute, Mashhad University of Medical Sciences, Mashhad, Iran
Ph.D. Student in Medical Physics, Mashhad University of Medical Sciences, Mashhad, Iran
M.Sc. in Industrial Design, Pouian Medical Equipment Engineering Company, Mashhad, Iran
چکیده
Introduction: Multileaf collimator (MLC) is state of the art among the radiation field shaping systems for conformal radiotherapy techniques. Some advantages of this system are as follow: reduction of treatment time, higher precision in conforming the radiation field to the projection of the target volume and lowering the chance of errors made by technologists. The purpose of this research was to design and construct the mechanical section of a prototype MLC. Material and Methods: The MLC consists of a base plate, ۵۲ leaves, ۲ leaf carriages, ۲ nuts and ۵۲ triangular thread screws. The leaves are arranged in two opposing banks each containing ۲۶ leaves. The carriages are used to extend the movement of the leaves. The components of the MLC are fabricated by machining processes. The MLC is designed to be mounted on the conventional linear accelerators as an add-on accessory. The leaves were made of aluminum. The dimensions of the leaves are ۵ x ۲۰۰ x ۵۰ mm. Result: The collimator system weighs approximately ۳۷kg excluding the leaves. The projected width of each leaf on the isocenter of a Varian linear accelerator is ۱۰ mm. The movement of the leaves is accomplished by using the triangular thread screws. The screws required to have a low axial backlash which in turn results in lower precision positioning of the leaves. The positioning accuracy of each leaf is approximately ۱.۴ mm. Discussion and Conclusion: Mashhad MLC system, in it’s present form and design weighs ۳۷ kg. but if Aluminum blades are replaced by tungsten ones then the over all weights of MLC may exceed the weight limit a linac may hold. Therefore futher modifications are required to reduce the MLC total weight. It is desirable to use ball screws and roller cages instead of triangular thread screws to achive a higher positioning pereision of the bladesکلیدواژه ها
Multileaf Collimator, Design, Fabrication, Mechanical partاطلاعات بیشتر در مورد COI
COI مخفف عبارت CIVILICA Object Identifier به معنی شناسه سیویلیکا برای اسناد است. COI کدی است که مطابق محل انتشار، به مقالات کنفرانسها و ژورنالهای داخل کشور به هنگام نمایه سازی بر روی پایگاه استنادی سیویلیکا اختصاص می یابد.
کد COI به مفهوم کد ملی اسناد نمایه شده در سیویلیکا است و کدی یکتا و ثابت است و به همین دلیل همواره قابلیت استناد و پیگیری دارد.