Construction of the LB-TRC test Machine to Study the Cold Crack
سال انتشار: 1401
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 108
متن کامل این مقاله منتشر نشده است و فقط به صورت چکیده یا چکیده مبسوط در پایگاه موجود می باشد.
توضیح: معمولا کلیه مقالاتی که کمتر از ۵ صفحه باشند در پایگاه سیویلیکا اصل مقاله (فول تکست) محسوب نمی شوند و فقط کاربران عضو بدون کسر اعتبار می توانند فایل آنها را دریافت نمایند.
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
INCWI23_086
تاریخ نمایه سازی: 16 اسفند 1401
چکیده مقاله:
This research has been done in order to create a new test method for hydrogen crackingofweld metal. The principle of this method, which is called LB-TRC test, is that two testsamples are connected together. Then a constant load is applied parallel to the weld.Depending on the amount of hydrogen, the stress level and the type of material, atransverse crack is created in the groove weld. Therefore, the test device does not need ahigh capacity in terms of load and size. Relationships between fracture stress and fracturetime were measured in ۱۱۰۱۸E electrode for ۳۷St steel. The obtained results showed thatthe critical stress was lower and the failure mode and graph obtained from the test in thetested LB-TRC samples were almost equal to what was obtained in the initial TRC test.Therefore, the LB-TRC test was useful for evaluating the susceptibility to cold crackingofthe weld metal.
کلیدواژه ها:
نویسندگان
Mehrdad Hosienpour
MS.C, Department of Materials Engineering, Amirkabir university, Tehran, Iran
Alireza Ebrahimi
Associate Professor, Department of Materials Engineering, Amirkabir university, Tehran, Iran