Real-Rcale Numerical Analyzing Dynamic Process of TBM Boring in Jointed Rock; a Case Study: Kerman Water Conveyance Tunnel in Iran
- سال انتشار: 1401
- محل انتشار: مجله معدن و محیط زیست، دوره: 13، شماره: 3
- کد COI اختصاصی: JR_JMAE-13-3_002
- زبان مقاله: انگلیسی
- تعداد مشاهده: 133
نویسندگان
Faculty of Mining, Petroleum and Geophysics Engineering, Shahrood University of Technology, Shahrood, Iran
Faculty of Mining, Petroleum and Geophysics Engineering, Shahrood University of Technology, Shahrood, Iran
Department of Mining Engineering, Director of Earth Mechanics Institute (EMI), Colorado School of Mines, USA
چکیده
One of the important cost items in mechanized tunneling is the cost of repairing or replacing the disc cutters that have suffered from normal wear during the boring of the hard abrasive rocks. For inspecting the health of the disc cutters, the boring operation shall be stopped, and after checking, the worn disc cutters may be replaced. In this work, the dynamic process of the TBM boring in the jointed rocks is simulated using a real-scale numerical analysis based on the rock fracturing factor using the discrete element method (DEM). The stress distributions induced within the disc cutters as well as the development of the plastic zones in the rock are investigated and compared with the actual results recorded in the Kerman water conveyance tunnel (KWCT). The numerical results indicate that the increase in the rock fracturing causes a decrease in the induced stresses and an increase in the size of the plastic zone. In other words, a higher penetration rate as well as more lifetime for disc cutters can be achieved in highly fractured rocks. Moreover, the average von Misses stress in the disc cutters in the highly fractured rocks is predicted about ۱۶-۲۳% less than stress induced in the slightly fractured rocks. Due to the TBM tunneling, the volume of the plastic zone as well as the actual penetration depth in the highly fracturing rocks are also about ۴۰% and ۴۲% higher than in the slightly fractured rocks under applying the same TBM parameters, respectively.کلیدواژه ها
Disc cutter, Normal wear, Real-scale numerical model, Discrete Element Method, Von Mises stressاطلاعات بیشتر در مورد COI
COI مخفف عبارت CIVILICA Object Identifier به معنی شناسه سیویلیکا برای اسناد است. COI کدی است که مطابق محل انتشار، به مقالات کنفرانسها و ژورنالهای داخل کشور به هنگام نمایه سازی بر روی پایگاه استنادی سیویلیکا اختصاص می یابد.
کد COI به مفهوم کد ملی اسناد نمایه شده در سیویلیکا است و کدی یکتا و ثابت است و به همین دلیل همواره قابلیت استناد و پیگیری دارد.