Modeling and Simulations of Multi-dimensional Thermal Behaviours of Plates during Friction Stir Additive Manufacturing
- سال انتشار: 1401
- محل انتشار: مجله مکانیک کاربردی محاسباتی، دوره: 53، شماره: 3
- کد COI اختصاصی: JR_JCAM-53-3_005
- زبان مقاله: انگلیسی
- تعداد مشاهده: 279
نویسندگان
Biomedical Engineering Dept., University of Lagos, Akoka, Lagos, +۲۳۴, Nigeria
Mechanical Engineering Dept., University of Lagos, Akoka, Lagos, +۲۳۴, Nigeria
چکیده
Friction-stir additive manufacturing is a type of solid-state additive manufacturing process that involves intense shear deformation of material during material joining process. The increasing application of the novel technology requires proper understanding of the inherent thermal process. The analysis of the transient thermal behaviour in three dimensions of the welded plates in friction-stir additive manufacturing is studied using Laplace transforms method is presented. It was established from the results that the material reduces in temperature during the simulation process as the distance of the point moving heat source increases from the centerline. Also, the time needed to attain the highest temperature increases with increasing distance between the point moving heat source and the centerline. In addition, the heating and cooling rates decrease while the distance between the point moving heat source and the centerline increases. The peak temperature is approximately ۱۲۰۰oC but this depends on the welding conditions, heat generation the materials. The variation of shoulder heat generation rate with welding rotational speed at different welding velocities of ۱۰۰-۲۰۰ mm/min depicts that increasing the tool rotational speed at constant weld speed increases the heat input, whereas the heat input decreases with an increase in the weld speed at constant tool rotational speed. It was also established that the fractional heat generation rate is between ۸۰ to ۹۰% heat is generated at the tool shoulder and the remaining amount at other tool surfaces. However, this depends on the welding conditions. Finally, the temperature profile typical features can be observed from the obtained results at varying monitoring points, and they provide a better analysis of the prevailing factors in the heat flow model for a point moving heat source. Hence, the model and analytical solution provide the benchmark for obtaining temperature profiles for point moving heat source during the additive manufacturing process.کلیدواژه ها
thermal analysis, Three-dimensional model, Frictional Stir Manufacturing, Analytical solutionsاطلاعات بیشتر در مورد COI
COI مخفف عبارت CIVILICA Object Identifier به معنی شناسه سیویلیکا برای اسناد است. COI کدی است که مطابق محل انتشار، به مقالات کنفرانسها و ژورنالهای داخل کشور به هنگام نمایه سازی بر روی پایگاه استنادی سیویلیکا اختصاص می یابد.
کد COI به مفهوم کد ملی اسناد نمایه شده در سیویلیکا است و کدی یکتا و ثابت است و به همین دلیل همواره قابلیت استناد و پیگیری دارد.