Stress Transfer Modeling in CNT Reinforced Composites using Continuum Mechanics (TECHNICAL NOTE)

سال انتشار: 1387
نوع سند: مقاله ژورنالی
زبان: انگلیسی
مشاهده: 113

فایل این مقاله در 8 صفحه با فرمت PDF قابل دریافت می باشد

استخراج به نرم افزارهای پژوهشی:

لینک ثابت به این مقاله:

شناسه ملی سند علمی:

JR_IJE-21-3_002

تاریخ نمایه سازی: 20 اسفند 1400

چکیده مقاله:

Because of the substantial difference in stiffness between matrix and nanotube in CNT composite, the stress transfer between them controls their mechanical properties. This paper investigates the said issue, analytically and numerically, in axial load using representative volume element (RVE). The analytical model was established based on the modified Cox’s shear lag model with the use of some simplified assumptions. Some, in the developed shear lag model, the CNT assumes hollow fiber. Solving the governing differential equation, led the high shear stress in interface especially in the CNT cap. In addition, some finite element models were performed with different aspect ratios and the shear stress pattern especially in interface was calculated numerically. Despite some simplified assumptions that were performed with these two models such as elastic behavior and full connectivity, and the comparison of their results with other numerical models show adequate agreement.

کلیدواژه ها:

نویسندگان

M. Yahyaeii

Civil Engineering, Khaje Nasir Toosi University of Technology

S. A. Sadrnejad

Civil Engineering, Khaje Nasir Toosi University of Technology

A. Chaboki Khiabani

Civil Engineering, Khaje Nasir Toosi University of Technology