Rankine Vortex Formation during Draining: A New Twin Port Suppression Strategy

سال انتشار: 1398
نوع سند: مقاله ژورنالی
زبان: انگلیسی
مشاهده: 126

فایل این مقاله در 14 صفحه با فرمت PDF قابل دریافت می باشد

استخراج به نرم افزارهای پژوهشی:

لینک ثابت به این مقاله:

شناسه ملی سند علمی:

JR_JAFM-13-1_012

تاریخ نمایه سازی: 15 دی 1400

چکیده مقاله:

This paper reveals the results of a study of vortex air core formation (Rankine vortex) when a rotated liquid (water) column in a cylindrical vessel is drained through two ports located at equal eccentricity (e) at the vessel base (diameter, d_۱and d_۲) simultaneously; d_۱is fixed whereas d_۲ is varied. Just before draining, a rotation (n rpm) is provided to the liquid column in controlled conditions. As draining progresses, when the liquid level reaches certain height called critical height (h_c), initially a surface dip forms which further develops in to a vortex extending down till the drain port. Results show that critical height increases as the fluid rotation rate increases at the lowest eccentricity. But, at higher eccentricities, h_c, exhibits more or less an increasing-decreasing trend in most of the cases studied. Critical height is observed to be minimum for the largest value of d_۲ (equal to d_۱) irrespective of the values of the speed of fluid rotation, liquid initial height and port eccentricity. To particularly note, at the highest eccentricity, vortex formation is found to be completely suppressed for all values of port diameter (d_۲) and initial fluid rotation (n) as indicated by the near-zero critical height values. The tangential velocity measurements using Particle Image Velocimetry are also reported. PIV results obtained for certain cases with induced fluid rotation (normal draining and faster draining) correlate well with the changes in the efflux (axial) velocity (deduced analytically) in these cases studied. The tangential velocity along radial direction obtained (PIV) also indicated the type of vortex formed in normal and faster draining cases. Video visualization of vortex formation carried out reveals that, vortex air core switching takes place between the drain ports maintaining an arched or curvilinear surface profile apart from demonstrating the nature of outlet flow discharge. All the vortex air core formation studies so far carried out were invariably with single drain port except the preliminary novel study by the same author group and the present study is a detailed extension of that novel study.

نویسندگان

M. Prabhu

Department of Mechanical Engineering, Amrita Vishwa Vidyapeetham, Amritapuri, India

R. Ajith Kumar

Department of Mechanical Engineering, Amrita Vishwa Vidyapeetham, Amritapuri, India

T. H. Gopikrishnan

Department of Mechanical Engineering, Amrita Vishwa Vidyapeetham, Amritapuri, India

P. J. Deshpande

UAV Division, CSIR-NAL Bengaluru, India

U. Anandhakrishnan

Department of Mechanical Engineering, Amrita Vishwa Vidyapeetham, Amritapuri, India

A. S. Kiran

Department of Mechanical Engineering, Amrita Vishwa Vidyapeetham, Amritapuri, India

R. P. Govindu

Department of Mechanical Engineering, Amrita Vishwa Vidyapeetham, Amritapuri, India