An Experimental Investigation of Surface Quality and Defects of Profiles in Wood-Plastic Composite Extrusion Process

سال انتشار: 1390
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 1,967

متن کامل این مقاله منتشر نشده است و فقط به صورت چکیده یا چکیده مبسوط در پایگاه موجود می باشد.
توضیح: معمولا کلیه مقالاتی که کمتر از ۵ صفحه باشند در پایگاه سیویلیکا اصل مقاله (فول تکست) محسوب نمی شوند و فقط کاربران عضو بدون کسر اعتبار می توانند فایل آنها را دریافت نمایند.

استخراج به نرم افزارهای پژوهشی:

لینک ثابت به این مقاله:

شناسه ملی سند علمی:

PPSRC2011_023

تاریخ نمایه سازی: 30 بهمن 1390

چکیده مقاله:

A problem that usually occurs in production of extruded parts of polymeric and in special wood-plastic composite (WPC) is flow instabilities at the extrusion die exit. In this paper influence of the important parameters of material and process on the surface quality (roughness) of extruded parts are investigated. The variable parameters are wood content, polymer melt flow index (MFI), screw speed, melt temperature, die diameter and finally length-to-diameter ratio of the die land. The Instabilities of die exit flow cause to defects on surface of profiles. The experiments specified that increasing die land length-to-diameter ratio (L/D), die temperature and wood content and decreasing screw speed and polymer MFI lead to improve the surface quality.

نویسندگان

Ehsan Soury

Nasr Bridge, P.O.Box ۱۴۱۱۵-۱۴۳, Faculty of Engineering, Tarbiat Modares University Tehran, Tehran, Iran