Behavior of a Tunnel and its Neighboring Joint with and without Presence of Rock Bolt under Biaxial Loads; Particle Flow Code Approach
محل انتشار: مجله معدن و محیط زیست، دوره: 11، شماره: 3
سال انتشار: 1399
نوع سند: مقاله ژورنالی
زبان: انگلیسی
مشاهده: 198
فایل این مقاله در 10 صفحه با فرمت PDF قابل دریافت می باشد
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
JR_JMAE-11-3_015
تاریخ نمایه سازی: 21 اردیبهشت 1400
چکیده مقاله:
In this work, the interaction between the semi-circular space and the neighboring joint with and without the presence of rock bolts was investigated using the particle flow code (PFC) approach. For this purpose, firstly, the calibration of PFC was performed using both the Brazilian experimental test and the uniaxial compression test. Secondly, a numerical model with the dimension of ۱۰۰ mm * ۱۰۰ mm was prepared. A semi-circular space with a radius of ۲۵ mm was situated below the model. A joint with a length of ۴۰ mm was situated above the space. The joint opening was ۲ mm. The joint angles related to the horizontal direction were ۰°, ۱۵°, ۳۰°, ۴۵°, ۶۰°, and ۷۵°. Totally, ۶ different configurations of the semi-circular space and neighboring joint were prepared. These models were tested with and without the presence of vertical rock bolts by the biaxial test. The rock bolt length was ۵۰ mm. The value of the lateral force was fixed at ۲ MPa. An axial force was applied to the model till the final failure occurred. The results obtained showed that the presence of rock bolts changed the failure pattern of the numerical model. In the absence of rock bolts, two tensile wing cracks initiated from the joint tip and propagated diagonally till coalescence from the model boundary. Also several shear bands were initiated in the left and right sides of the tunnel. In the presence of rock bolts, several shear bands were initiated in the left and right sides of the tunnel. The compressive strength with the presence of rock bolts was more than that without the presence of rock bolts. The failure stress had a minimum value when the joint angle was ۴۵°.
کلیدواژه ها:
نویسندگان
V. Sarfarazi
Department of Mining Engineering, Hamedan University of Technology, Hamedan, Iran
مراجع و منابع این مقاله:
لیست زیر مراجع و منابع استفاده شده در این مقاله را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود مقاله لینک شده اند :