Prediction of Tool Force in Two Point Incremental Forming by Slab Analysis
محل انتشار: ماهنامه بین المللی مهندسی، دوره: 33، شماره: 11
سال انتشار: 1399
نوع سند: مقاله ژورنالی
زبان: انگلیسی
مشاهده: 197
فایل این مقاله در 9 صفحه با فرمت PDF قابل دریافت می باشد
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
JR_IJE-33-11_030
تاریخ نمایه سازی: 6 اردیبهشت 1400
چکیده مقاله:
Two-Point Incremental Forming (TPIF) method is a novel technique for producing free form shell parts. The main purpose of this study is to analyze the TPIF process, and, by approximate calculation, to find the force applied to the tool. One of the limitations of an incremental forming process is that during this process force applied to the tool is born by the machine. In this research, an equation for approximate prediction of the force applied to the tool is presented using the values of the yield stress of the sheet, friction coefficient, tool radius and thickness of the sheet; hence, the applied force can be calculated. By increasing the forming angle, the amount of the created local strain increases and the change in thickness and the force applied to the tool is enhanced. However, by increasing the angle of punch wall, less compressive stress is applied to the metal sheet due to the reduction in contact between the surface of the tool and punch wall. Analytical equations presented are validated by the results from experimental tests.
کلیدواژه ها:
نویسندگان
M. Esmailian
Department of Mechanical Engineering, University of Birjand, Birjand, Iran
K. Khalili
Department of Mechanical Engineering, University of Birjand, Birjand, Iran
مراجع و منابع این مقاله:
لیست زیر مراجع و منابع استفاده شده در این مقاله را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود مقاله لینک شده اند :