The Effect of Artificial Aging Treatment and Lubrication Modes on the Cutting Force and the Chip Surface Morphology when Drilling Al-Si-Mg (A356) Cast Alloys

سال انتشار: 1397
محل انتشار: فصلنامه فرایندهای نوین در ساخت و تولید، دوره: 7، شماره: 1
کد COI اختصاصی: JR_MPMPJ-7-1_004
زبان مقاله: انگلیسی
تعداد مشاهده: 283

نویسندگان

School of Mechanical Engineering, Iran University of Science and Technology, Tehran, Iran

چکیده

This article reports the effects of various artificial aging methods and lubrication modes (dry, mist, wet) on the recorded cutting forces and chip morphology in drilling Al-Si-Mg (A356) cast alloys. In the course of this work, the work part sampled were as-received alloy (T0), solution heat-treated alloy (SHT) and then aged alloys at 155°C, 180°C, and 220°C (T4, T6, T61, T7), respectively. The significant effects of artificial aging the recorded cutting forces were noticed. Except minor cases under lower levels of feed rate, in general lower cutting forces were observed in A356-T0 and A356-T7 which are more brittle than other tested alloys. A direct relationship can be formulated among the microcracks on the free surfaces of the chips, brittleness and the recorded cutting forces. The use of MQL led to lower resulting cutting forces under similar cutting conditions. This can be related to less effect of thermo-mechanical stresses on the work part under MQL mode which tends to reduce the cutting forces.

کلیدواژه ها

Aluminum Alloys, Heat treatment, Artificial Aging, Surface Quality, Cutting force

اطلاعات بیشتر در مورد COI

COI مخفف عبارت CIVILICA Object Identifier به معنی شناسه سیویلیکا برای اسناد است. COI کدی است که مطابق محل انتشار، به مقالات کنفرانسها و ژورنالهای داخل کشور به هنگام نمایه سازی بر روی پایگاه استنادی سیویلیکا اختصاص می یابد.

کد COI به مفهوم کد ملی اسناد نمایه شده در سیویلیکا است و کدی یکتا و ثابت است و به همین دلیل همواره قابلیت استناد و پیگیری دارد.