Electrostatic effects on investigation of dispersed droplets in dielectric liquids
- سال انتشار: 1390
- محل انتشار: نوزدهمین همایش سالانه مهندسی مکانیک
- کد COI اختصاصی: ISME19_017
- زبان مقاله: انگلیسی
- تعداد مشاهده: 2227
نویسندگان
Heat and Fluid Flow Research Laboratory, Mechanical Engineering Department, the University of Tabriz
چکیده
Electrostatic atomization of liquids is now considered as a well established technique for creating finely mono-dispersed liquid droplets. One of the techniques in producing stable emulsion is to make finer droplets of dispersed liquids using electrohydrodynamic actuators. This work is to investigate the hydrodynamics of dispersed droplets of water in a continuum dielectric fluid of silicon 100Cst. The effects of flow rate of liquid jet, applied voltage and electrical conductivity of liquids on droplet motion and its deformation were considered. By a nozzle with inner diameter of 1.4 mm water and chloride potassium droplets were generated and were forwarded into the dielectric silicon oil as a base of quiescence medium .In order to produce fine droplets, EHD actuator which produce a high voltage between nozzle and a ring as a ground electrode were used. By this method, a stable water and chloride potassium droplets in oil without any surfactants was produced. It was observed that increasing in flow rate of injection educes the effect of EHD on droplet size decreasing. Droplet Injection from nozzle causes different patterns which have been strongly depended on strength of electric field. In this work, two kinds of flow patterns were considered: dripping mode and spray jet mode. The behaviour of droplets depends on sizes which are completely difference for above mentioned modes. The conductivity of dispersed media is important in dielectric base. For KCL solution with more conductivity than water it is observed the direct effects of this property on diminishing of droplet sizeکلیدواژه ها
Droplet size, Dielectric liquid media,Conductivity, Electrohydrodynimicمقالات مرتبط جدید
- توسعه مبدل حرارتی داخلی ( IHX ) از طریق تغییر فرآیند ساخت و تولید لوله های گاز کولر در صنعت خودروسازی
- بهبودعملکرد سیکل تبرید تراکمی با تغییر فرآیند ساخت مبدل SLHX از آرایش مماسی به هم مرکز
- بررسی تاثیر لایه میانی روی در اتصال غیر مشابه آلیاژ پایه منیزیم AZ۳۱ و آلومینیوم ۶۰۶۱ به روش جوشکاری اصطکاکی اغتشاشی نقطهای
- بررسی تجربی سوراخکاری کامپوزیتهای پلیمری: مقایسه جوت و شیشه
- سیستم هوشمند پایش وضعیت بلبرینگ با استفاده از طیفنگاره صوتی جهت طبقهبندی و تشخیص خطای بلبرینگ ها
اطلاعات بیشتر در مورد COI
COI مخفف عبارت CIVILICA Object Identifier به معنی شناسه سیویلیکا برای اسناد است. COI کدی است که مطابق محل انتشار، به مقالات کنفرانسها و ژورنالهای داخل کشور به هنگام نمایه سازی بر روی پایگاه استنادی سیویلیکا اختصاص می یابد.
کد COI به مفهوم کد ملی اسناد نمایه شده در سیویلیکا است و کدی یکتا و ثابت است و به همین دلیل همواره قابلیت استناد و پیگیری دارد.