Application of Oscillating Saw for Lumbar en Bloc Laminectomy: A Case Series

  • سال انتشار: 1399
  • محل انتشار: مجله استخوان و جراحی عمومی، دوره: 8، شماره: 3
  • کد COI اختصاصی: JR_TABO-8-3_013
  • زبان مقاله: انگلیسی
  • تعداد مشاهده: 566
دانلود فایل این مقاله

نویسندگان

Farshad Nikouei

Bone and Joint Reconstruction Research Center, Shafa Orthopedic Hospital, Iran University of Medical Sciences, Tehran, Iran ۲ Faculty of Medicine,

Naveed Nabizadeh

Bone and Joint Reconstruction Research Center, Shafa Orthopedic Hospital, Iran University of Medical Sciences, Tehran, Iran

Elham Mirzamohammadi

Faculty of Medicine, Iran University of Medical Sciences, Tehran, Iran

Maryam Ameri

Department of Forensic Medicine and Toxicology, Iran University of Medical Sciences, Tehran, Iran

چکیده

Background: An oscillating bone saw is rarely used to perform laminectomy. The purpose of this study was to describea relatively quick and harmless technique for multilevel laminectomy in patients with lumbar spinal stenosis (LSS) usingan oscillating bone saw to find out how this instrument affects the time of surgery and rate of complications.Methods: This prospective study was conducted on 45 patients with LSS who required multilevel laminectomy. Thebones were cut using an oscillating sagittal saw equipped with a fine 1-cm blade. Posterolateral fusion was performed ifany evidence of spinal instability occurred, or the correction of deformity was addressed. The time spent for laminectomyfrom initial cutting to the whole bone removal (T1) and the duration of laminectomy (i.e., from initiation to the end ofdecompression; T2) were recorded for the corresponding level. The volume of harvested autograft was also measured,and any dural injuries were reported.Results: Posterolateral fusion was performed on 32 (71.1%) patients. The mean T1 and T2 per level were estimated at70.5±5.4 and 157.5±12.1 sec, respectively. In addition, the mean volume of harvested autograft per level was obtainedas 3.5±1.2 cc. No durotomy was observed during laminectomy using an oscillating bone saw. However, a dural tearoccurred in one patient when a Kerisson punch was utilized for ligamentum flavum removal and foraminotomy.Conclusion: Based on the findings, it can be concluded that laminectomy by means of the oscillating bone saw is asafe procedure that provides a sufficient volume of harvested autograft for fusion. This technique could also induce aremarkable reduction in the time of surgery.Level of evidence: IV

کلیدواژه ها

decompression, laminectomy, lumbar spine, oscillating saw, Stenosis

اطلاعات بیشتر در مورد COI

COI مخفف عبارت CIVILICA Object Identifier به معنی شناسه سیویلیکا برای اسناد است. COI کدی است که مطابق محل انتشار، به مقالات کنفرانسها و ژورنالهای داخل کشور به هنگام نمایه سازی بر روی پایگاه استنادی سیویلیکا اختصاص می یابد.

کد COI به مفهوم کد ملی اسناد نمایه شده در سیویلیکا است و کدی یکتا و ثابت است و به همین دلیل همواره قابلیت استناد و پیگیری دارد.