Upper Bound Analysis of Tube Extrusion Process Through Rotating Conical Dies with Large Mandrel Radius
محل انتشار: فصلنامه مکانیک جامد، دوره: 7، شماره: 2
سال انتشار: 1394
نوع سند: مقاله ژورنالی
زبان: انگلیسی
مشاهده: 247
فایل این مقاله در 13 صفحه با فرمت PDF قابل دریافت می باشد
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
JR_JSMA-7-2_006
تاریخ نمایه سازی: 27 فروردین 1399
چکیده مقاله:
In this paper, an upper bound approach is used to analyze the tube extrusion process through rotating conical dies with large mandrel radius. The material under deformation in the die and inside the container is divided to four deformation zones. A velocity field for each deformation zone is developed to evaluate the internal powers and the powers dissipated on all frictional and velocity discontinuity surfaces. By minimization of the total power with respect to the slippage parameter between tube and the die and equating it with the required external power, the extrusion pressure is determined. The corresponding results for rotating conical dies are also determined by using the finite element code, ABAQUS. The analytical results show a good coincidence with the results by the finite element method with a slight overestimation. Finally, the effects of various process parameters such as mandrel radius, friction factor, etc., upon the relative extrusion pressure are studied.
کلیدواژه ها:
نویسندگان
H Haghighat
Mechanical Engineering Department, Razi University, Kermanshah
M.M Mahdavi
Mechanical Engineering Department, Razi University, Kermanshah
مراجع و منابع این مقاله:
لیست زیر مراجع و منابع استفاده شده در این مقاله را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود مقاله لینک شده اند :