ENERGY AND EXERGY INVESTIGATION OF PARABOLIC TROUGH COLLECTORS (PTC)
محل انتشار: اولین همایش ملی انرژی های نو وپاک
سال انتشار: 1392
نوع سند: مقاله کنفرانسی
زبان: انگلیسی
مشاهده: 2,077
فایل این مقاله در 20 صفحه با فرمت PDF قابل دریافت می باشد
- صدور گواهی نمایه سازی
- من نویسنده این مقاله هستم
استخراج به نرم افزارهای پژوهشی:
شناسه ملی سند علمی:
CCE01_204
تاریخ نمایه سازی: 12 شهریور 1392
چکیده مقاله:
In this paper, the effect of evacuated glass cover on convective heat loss and exergetic efficiency is studied. First, the evacuated receiver tube of LS-2 parabolic trough collector is simulated and analyzed with computational fluid dynamics (CFD) to compare with Dudley’sexperimental data at Sandia National Research Laboratory (SNRL). The results have good agreements with tested results. Secondly, this mentioned collector and its absorber tube are simulated without evacuated glass cover for various wind speeds and collector orientations. The temperatures of the receiver tube and ambient are assumed 350 and 300 K respectively. Finally, exergetic analysis of each case-studies are calculated and effect of wind blast and collector orientation on the exergy destruction and exergy loss are investigated. It is found that when wind blows on the convex side of the parabolic mirror, the impressibility of outlet temperature from wind speed is least than other orientations. Also, if the wind blows on the convex side of the parabolic mirror, the impressibility of outlet temperature from the variation of orientation is most than other orientations. Also, With increasing of orientation angle from -90 to 90, the exergy loss and destruction of collector increase. Therefore exergy efficiency of collector will be decreases. With increasing of wind blast from 5 to 15, the exergy loss and the destruction of collector increase. Therefore exergy efficiency of collector will be decreases. Also, using evacuated tube leads to increasing of exergy from 10% to 60%.
کلیدواژه ها:
نویسندگان
Omid Karimi Sadaghiyani
Department of Mechanical Engineering, Urmia University of technology, Urmia, Iran
S.Mansureh Khaljani
Department of Mechanical Engineering, Sahand University of technology, Tabriz, Iran
M.Mohammad Sadeghi Azad
Department of Mechanical Engineering, Urmia University of technology, Urmia, Iran
Iraj Mirzaee
Department of Mechanical Engineering, Urmia University, Urmia, Iran
مراجع و منابع این مقاله:
لیست زیر مراجع و منابع استفاده شده در این مقاله را نمایش می دهد. این مراجع به صورت کاملا ماشینی و بر اساس هوش مصنوعی استخراج شده اند و لذا ممکن است دارای اشکالاتی باشند که به مرور زمان دقت استخراج این محتوا افزایش می یابد. مراجعی که مقالات مربوط به آنها در سیویلیکا نمایه شده و پیدا شده اند، به خود مقاله لینک شده اند :